How to Align Garage Door Eye Sensors

How to Align Garage Door Eye Sensors

Garage door eye sensors (also known as safety sensors) are a critical component of your overhead door system. If you’re having trouble with your garage door eye sensors, read on or watch the video below for some tips on resolving the problem.

Introduction to Eye Sensors

Eye sensors are two little light sensors at the bottom of your door. They are typically six inches up from the floor and attached right to the track. When the eye sensors are aligned, meaning the sending sensor’s laser is being read by the receiving sensor, your door will open and close properly. If one or both eye sensors are out of alignment, your door will try to come down but instead come right back up.

Garage Door Eye Sensor, Utah, Eye Sensors, Garage Door Repair
Eye Sensors are the little boxes attached to the bottom of your garage door track. They shoot laser beams at each other. You’ve probably made a fool of yourself jumping over them at some point.

How to Align Eye Sensors

Let’s dive into what it takes to get your door closed today. First, get down on the level of your eye sensors and look for a green light on the receiving unit, and a yellow light on the sending unit. So long as you have power and the doors are open, the yellow light should always be on. If it isn’t, you have an electrical problem, not necessarily an eye sensor problem. This could be anything from a stapled wire to a power outage. You’ll want to check around for something obvious, like a breaker switch, before calling a professional. 

Once you’ve confirmed the yellow light is on, the next thing to look for is the green receiving light. If the green light is off, you’ll need to align your eye sensors. Rather than wiggling the brackets themselves, the easiest way to go about this will be loosening the wing nut that screws into the sensor. Once the wing nut is loosened, realigning the sensors should be a breeze!

Make sure to adjust the eye sensors on all axes. Move them forwards, backwards, inside, and out. 

Troubleshooting Your Eye Sensors

Once the eye sensors are aligned and both lights are on, the next thing to look for would be something obstructing the laser between the two sensors. There might be a cobweb, hard water buildup, or other debris in front of either unit. 

Another common issue is loose, rattling tracks that shake the sensors as the door is coming down. If the green light is flickering during the door’s opening or closing, the problem might not be your eye sensor’s alignment… it may be your rattling doors.

Thank you for tuning in. If that did solve your problem, you’re welcome. If not, please give us a call today. We’re happy to help.

The post How to Align Garage Door Eye Sensors first appeared on A Plus Garage Doors. This post first appeared on https://utahgaragedoors.net

Leave a Reply

Your email address will not be published. Required fields are marked *

This website nor its owners are an actual service provider, this website is a referral service. When you place a phone call from this website, it will route you to a licensed, professional service provider that serves your area. For more information refer to our terms of service.

© HomeGarageDoorRepair.com

Call Now Button(877) 959-3534